Skip to main content

Ouellet OWC-M0300 Heating Cable Mat for Concrete, 240/208V, 28 Sq. Ft. Coverage, 300W

Ouellet Electric Heating

$269.00
(No reviews yet) Write a Review
UPC:
625262437632
Voltage:
240/208V
Wattage:
300W
Adding to cart… The item has been added
PICTURE MAY NOT REPRESENT ACTUAL ITEM FINISH. PLEASE REFER TO PRODUCT DESCRIPTION.

Features
• 240/208V
• Twin conductor heating cable attached to a plastic mat with negligible magnetic field
• Watt density: 11W/sq. ft., factory installed on mat at 6" spacing
• Installation with or without metallic structure for reinforced concrete

Application
• Basement, garage, bathroom, kitchen, family room, workshop, pool, shower, entrance way, hospital, hotel, factory, business, restaurant, sunroom, greenhouse, buildings used for housing animals

Cold Lead Length
• 8' 2" (2.5 m) cold lead included

Control
• Two types of control method possible (see instruction manual for details):
- Surface heating control with electronic thermostat in floor mode (F) and temperature sensor
- Ambient heating control with electronic thermostat in ambient mode with floor limit (A or AF) and temperature sensor
• Note: A ground fault circuit interrupter (GFCI) must be used with this heating device unless exempted by the applicable national and/or local electrical code for the area of installation

Included Materials
• 15' (4.6 m) temperature sensor
• Plastic floor fasteners (KIT-WC-CLP)
• Measurements table label (to be placed in electrical panel)

Installation
• Never cut or shorten the heating cable
• For indoor applications only, residential or commercial
• Installs under a 4" to 6" (10 cm to 15 cm) concrete slab or under a 1.5" to 4" concrete topping (4 cm to 10 cm)
• Note: It is highly recommended to insulate the concrete slab in order to avoid heat loss from below

For more information, Click Here - PDF

Please contact us for any additional options seen on specification sheet.