Skip to main content

SunTouch SC50240105 (81011402) ProMelt Electric Snow and Ice Melt Cable, 240 VAC, 105 Square Ft.

SunTouch

$1,128.18
(No reviews yet) Write a Review
UPC:
840213100025
Voltage:
240 VAC
Adding to cart… The item has been added
Application
• ProMelt Cables are used to melt ice or snow from an exterior surface and are designed for outdoor use only, embedded in concrete, asphalt, or sand
• Minimum Bend Radius: 1 inch
• Maximum Exposure Temperature (continuous and storage): 221°F (105°C)
• Maximum Exposure Temperature (short-term for asphalt covering): 285°F (140°C)
• Minimum Installation Temperature: 40°F (4.5°C)

Installation Paramaters
• Determine a time to install the cable when equipment, heavy tools, and site traffic will be minimal
• Apply the surfacing courses over the cable the same day the cable is installed
• If installing cable in the upper layer of a two-stage concrete slab or the upper layer of an asphalt application, the cable should be completely ready for the second stage. There is limited time between stages, as the slab should not be allowed to fully cure or the asphalt to completely cool. Therefore, lay out the cable and tie it to rewire that can be quickly lifted into place after the first stage is laid
• If a slab sensor is installed in this second layer, plan ahead so this does not cause the first layer to cure or cool too much
• Inspect the area and remove any sharp objects
• Install in temperatures at least 40°F (4.5°C)

For more information, Click Here - PDF

Please contact us for any additional options seen on specification sheet.