The Wafer LED Downlight with Switchable White provides high-quality light output and efficiency featuring a switch for easy color temperature adjustment - while eliminating the need for recessed housings. The innovative, slim design allows for easy retrofit, remodel or new construction installation from below the ceiling. The Wafer LED downlight is wet location listed - making it ideal for use in outdoor residential, hospitality, commercial and multifamily applications. The LED module maintains at least 70% light output for 50,000 hours.
Construction
• Aluminum die cast outer frame
• Durable, powder coat paint to prevent rust
• FT4 plenum rated cable connector to connect from module to remote driver box
• IC rated driver with convenience and value of selectable color temperature using the switch
• The isolated driver integrated inside steel remote box with four 7/8" knockouts with slots for pryout
• Suitable for pulling wires with the 12 cubic-inch wiring compartment to accommodate up to (6) 14 gauge insulated conductors, or (4) 12 gauge insulated conductors
Installation
• Ideal for shallow ceiling plenum; no housing required
• Steel spring clip for easy installation
• Cut out template is provided to ensure a correct sized hole is cut into ceiling for proper installation of the trim
• Suitable for installation in t-grid and drop ceiling applications
• 3" plenum space required for installation of the remote driver box
Optics
• Edge-lit LED technology uses light guided plate to distribute light
• Polycarbonate lens provides even illumination throughout the space
Electrical
• Multi-volt (120-277V, 50/60Hz) proprietary remote LED driver/splice box, with two (2) additional low-voltage wires for 0-10V dimming, down to 10% (depending on dimmer model and application)
• High efficient driver with power factor > 0.9
• Ambient operating temperature: -40°F (-40°C) to +104°F (+40°C)
Listings
• CSA certified to US and Canadian safety standards
• ENERGY STAR certified
• Wet location
• Air Tight certified in accordance with ASTM E283-2004
• NOM Certified
• Can be used to comply with California Title 24 Part 6 High Efficacy LED light Source Requirements
For more information, Click Here - PDF
Please contact us for any additional options seen on specification sheet.
Construction
• Aluminum die cast outer frame
• Durable, powder coat paint to prevent rust
• FT4 plenum rated cable connector to connect from module to remote driver box
• IC rated driver with convenience and value of selectable color temperature using the switch
• The isolated driver integrated inside steel remote box with four 7/8" knockouts with slots for pryout
• Suitable for pulling wires with the 12 cubic-inch wiring compartment to accommodate up to (6) 14 gauge insulated conductors, or (4) 12 gauge insulated conductors
Installation
• Ideal for shallow ceiling plenum; no housing required
• Steel spring clip for easy installation
• Cut out template is provided to ensure a correct sized hole is cut into ceiling for proper installation of the trim
• Suitable for installation in t-grid and drop ceiling applications
• 3" plenum space required for installation of the remote driver box
Optics
• Edge-lit LED technology uses light guided plate to distribute light
• Polycarbonate lens provides even illumination throughout the space
Electrical
• Multi-volt (120-277V, 50/60Hz) proprietary remote LED driver/splice box, with two (2) additional low-voltage wires for 0-10V dimming, down to 10% (depending on dimmer model and application)
• High efficient driver with power factor > 0.9
• Ambient operating temperature: -40°F (-40°C) to +104°F (+40°C)
Listings
• CSA certified to US and Canadian safety standards
• ENERGY STAR certified
• Wet location
• Air Tight certified in accordance with ASTM E283-2004
• NOM Certified
• Can be used to comply with California Title 24 Part 6 High Efficacy LED light Source Requirements
For more information, Click Here - PDF
Please contact us for any additional options seen on specification sheet.
