Features
• Low profile, two-circuit track sections for surface or pendant mounting
• Provides two separate 20-amp circuits from a single electrical feed or one 20-amp circuit controlled by two switches
• I-beam cross section provides added strength and rigidity in pendant suspended applications
• Compatible with a full range of feed, connector and mounting accessories to complete virtually any installation requirement
• Accepts all Trac-Master and Trac-Lites track fixtures, which have a moveable "hot" contact to allow operation using circuit (or switch leg) 1 or 2
Construction
• Extruded aluminum "I" beam channel
• One-piece thermoplastic insulator
• Injection molded polycarbonate dead-end with set screw
• Standard lengths may be cut-to-length by installer
Electrical
• Three 12 gauge solid copper conductors
• Each circuit rated 20 amps at 120 volts (40 amps total)
• Aluminum channel used as system ground
• One-piece insulator insures consistent conductor spacing for reliable electrical contact
• Insulating bushings supplied at mounting hole locations to prevent shorts to ground
Installation
• Debossed polarity line provides visual cue to proper track, track connector and fixture alignment
• Supplied with toggle bolts for surface mounting
• Integral raceway in top of channel accommodates pendant mounting hardware and wire routing to electrical feed
• Insulator stays same length as extrusion to simplify field-cutting of track
• Connectors and feeds simply push into track sections
For more information, Click Here - PDF
Please contact us for any additional options seen on specification sheet.
• Low profile, two-circuit track sections for surface or pendant mounting
• Provides two separate 20-amp circuits from a single electrical feed or one 20-amp circuit controlled by two switches
• I-beam cross section provides added strength and rigidity in pendant suspended applications
• Compatible with a full range of feed, connector and mounting accessories to complete virtually any installation requirement
• Accepts all Trac-Master and Trac-Lites track fixtures, which have a moveable "hot" contact to allow operation using circuit (or switch leg) 1 or 2
Construction
• Extruded aluminum "I" beam channel
• One-piece thermoplastic insulator
• Injection molded polycarbonate dead-end with set screw
• Standard lengths may be cut-to-length by installer
Electrical
• Three 12 gauge solid copper conductors
• Each circuit rated 20 amps at 120 volts (40 amps total)
• Aluminum channel used as system ground
• One-piece insulator insures consistent conductor spacing for reliable electrical contact
• Insulating bushings supplied at mounting hole locations to prevent shorts to ground
Installation
• Debossed polarity line provides visual cue to proper track, track connector and fixture alignment
• Supplied with toggle bolts for surface mounting
• Integral raceway in top of channel accommodates pendant mounting hardware and wire routing to electrical feed
• Insulator stays same length as extrusion to simplify field-cutting of track
• Connectors and feeds simply push into track sections
For more information, Click Here - PDF
Please contact us for any additional options seen on specification sheet.
